Powercom 625A Uživatelský manuál Strana 1

U P SUninterruptible Power SystemLine Interactive UPS 325A/425A/525A/625ALine Interactive Network UPS 425AP/525AP/625APUSER‘S MANUAL

5. Operation______________________________________________________________ 5.1 Switch onWith the UPS plugged in, press and hold the on/off/test/si

6. Alarm_______________________________________________________________6.1 "BACK UP" (slow alarm)When in BACK UP mode, the YELLOW LED illum

7. Software options______________________________________________________________7.1 UPSMON SoftwareThe UPSMON software is applied standard RS-232 int

8. Computer Interface Port______________________________________________________________The computer interface port has the following characteristics:

9. Battery Replacement______________________________________________________________Your battery should run any where from 3-5 years before eve needin

10. Troubleshooting______________________________________________________________PROBLEM POSSIBLE CAUSE ACTION TO TAKEOn/off/test/silencebutton not pu

11. Storage______________________________________________________________10.1 Storage conditionsStore the UPS covered and upright in a cool , dry loca

TypicalRecharge Time4 hours (to 90% of full capacity)Protection Automatic self-test & discharge protection, replace batteryindicatorBack up Time10

Important safety instructions_______________________________________________________________Thank you for selecting this uninterruptible power system

Table of contents______________________________________________________________1. Introduction… … … … … … … … … … … … … … ..12. Safety… … … … … … … …

1. INTRODUCTION_______________________________________________________________The product is line interactive UPS with the newest technology and power

2. Safety_______________________________________________________________CAUTION !●To reduce the risk of electric shock, disconnect the UPS from the ma

3. Presentation______________________________________________________________FRONT PANEL3.1 "REPLACE BATTERY" indicator (RED LED)The LED ill

____________________________________________________________REAR PANEL3.5 COMPUTER INTERFACE (425AP/525AP/625AP models only)Provide both RS-232 and re

4. Installation______________________________________________________________4.0 InspectionInspect the UPS upon receipt. The packaging is recyclable;

4.5 Connect the loadsPlug the loads into the output connectors on the rear of the UPS. To use theUPS as a master on/off switch, make sure all of t